Xinjiang Agricultural Sciences ›› 2019, Vol. 56 ›› Issue (3): 544-550.DOI: 10.6048/j.issn.1001-4330.2019.03.018

Previous Articles     Next Articles

Influence of Different Curved Surface Graft Dividers on Graft Distribution and Analysis of Their Working Force

YI Zhe-tian1, WEN Hao-jun1,2, PAN Fo-chu1   

  1. 1. School of Mechanical and Electrical Engineering, Shihezi University, Shihezi Xinjiang 832000, China;
    2. Key Laboratory of Agricultural Equipment in Northwest China, Ministry of Agriculture, Shihezi Xinjiang 832000, China
  • Received:2018-12-12 Online:2019-03-20 Published:2019-06-25
  • Correspondence author: Wen Hao-jun, Ph.D. supervisor,(E-mail) 547273950@qq.com
  • Supported by:
    Supported by the National Key R & D Program (2016YFD0200705 and 2017YFD0201904)

不同曲面分禾器对分禾的影响及其作业受力分析

易哲田1, 温浩军1,2, 潘佛雏1   

  1. 1.石河子大学机械电气工程学院,新疆石河子 832000;
    2. 农业部西北农业装备重点实验室,新疆石河子 832000
  • 通讯作者: 温浩军,博士生导师,,(E-mail)547273950@qq.com
  • 作者简介:易哲田,硕士研究生,研究方向为农业机械,(E-mail)yizhetian@cctv.admin.edu.pl
  • 基金资助:
    国家重点研发计划(2016YFD0200705,2017YFD0201904)

Abstract: Objective To solve the problems caused by dense planting and cultivation mode of cotton in Xinjiang. For example, the fog droplets could not penetrate the crop canopy and the effect of insecticides on the middle and lower parts of cotton plants was poor.Method Through the establishment of a digital model based on mathematical theory, the transient stress analysis of the grain divider and the elastic deformation analysis of cotton branch were carried out.Results Under the same disturbance, the pressure on the splitting surface caused by the same force on the parabolic surface decreased gradually, and it dropped to 23N at the end of the divider. Conclusion The parabolic surface divider has the lowest passing resistance and is the best dividing type among the three dividers.

Key words: cotton ; rice divider; dense planting; cotton canopy; bending modulus of elasticity

摘要: 目的 研究棉花密植栽培模式下,雾滴无法穿透棉花冠层,影响植株中下部受药效果,研究不同曲面分禾器对分禾的影响及其作业受力分析。方法 建立以数学理论为基础的数字化模型,对分禾器工作瞬态作受力分析、棉枝弹性形变分析。结果 在相同扰动情况下,抛物线曲面上同一作用力对分禾曲面造成的压力逐渐减小,在分禾器末端降至23N。结论 抛物线曲面分禾器在通过阻力最低,为三种分禾器中效果最佳的分禾型式。

关键词: 棉花, 分禾器, 密植, 冠层, 弯曲弹性模量

CLC Number: